Motion sensor not turning light off

I cannot get the Shelly Motion Sensor to turn the light off.

It switches the light on.

The 9 GU10 Bulbs are controlled by a Shelly 1L and it works.

I've tried to put the following in The Shelly 1L I/O URL Actions/BUTTON 1 SWITCHED ON URL

http://192.168.X.XXX/relay/0?turn=on

( I wrote the correct numbers instead of X )

and in BUTTON 1 SWITCHED OFF URL I wrote:-

http://192.168.X.XXX/relay/0?turn=off

In the motion sensor Blind time is 1

Can anyone help.

RESOLVED

I have to GO TO THE MOTION SENSOR NOT THE RELAY

So open Motion sensor by entering the IP of your Motion sensor in your browser NOT from the dashboard.

Actions/MOTION DETECTED /Check Enabled and enter this (you have to enter your IP for your light) Where there is an X you put your IP number.

http://192.168.1.211/relay/0?turn=on

From: 00:00 To 00:00

Then 4 lines down I will see :-

END OF MOTION DETECTED

ENETER THIS:-

http://XXX.XXX.X.XXX/relay/0?turn=off

From: 00:00 To 00:00

Note :- The problem was under END OF MOTION DETECTED it read =on believe it or not.