Hi,
I installed a dimmer 2 ( line + neutral ) on a brand new 80w led ceiling light ( led strip with driver - Lucide 46100/80/30 ) but the balast makes a loud buzzing sound at any dimming percentage.
I can only calibrate with trailing edge ( leading fail ) and during the calibration the balast makes little to no noise ( little on low dimming, none on full light )
After calibration is done and switching on the light, there is still a loud buzzing noise at any % ( on full light shelly reports 78W so i assume it's not really 100%
What are my options? Replace the led driver? Ditch the shelly?
I could use some insight =)
Regards