Working with switch

Hi,

I have classic switch with shelly 1 and shelly motion. I can switch on / off light with switch and sensor. When i come into the room the sensor lights up. When I leave and turn off the light switch, the sensor does not work for 1 minute. This is the smallest blind time value that can be set. Is there a way to make sure that the sensor and switch work and remember the latest state? Something like an edge mode for turning on and off through an application.

Zitat

Turn off the shelly1 with 60 seconds delay.

I have it set up through the scene. When the sensor detects movement, I turn on the relay. In the second scene, the opposite. How do I turn off shelly 1 for 1 minute? Doesn't the light go out immediately or will it go off with the switch?

Zitat

You can choose edge mode to trigger the Shelly to turn its output on and use a delayed off function of 20 seconds for example, to turn it off.

The thing is that the motion sensor will not be ready, to detect a next motion, before the 60 seconds have elapsed.

Therefore it's always wise to select a sensor with a short blind time.

Oh sorry, I didn' see, that you are writing of the Shelly motion sensor, so there is not much choice.

So shelly motion cannot be use with manual switch?