How to update the firmware of a Shelly Door Window 2 ?

  • Hi,

    How to update the firmware of a Shelly Door Window 2 ? On the web interface of my shelly door, it says I can update and so I run it. But nothing happens. I get back this message:

    2022-04-28_16h30_09.png

    Does this has to do with the sleep/wake up of the device ? How can I wake up the device ? It's speaks about the "button", but I don't see any button on the device.

    Thanks

    Fred

  • LG Michael

    Einsteigertipps / Tips for beginners

    Meine Shellys:

    In Betrieb:

    Zur Zeit über 150 Shellys, in der Regel alle Cloudverbunden

    Testboard mit fast jedem Shellytyp auf dem Markt.

    Fast 5 Jahre kein übergeordnete System. Nur mit App und WebUI mit Cloudverbindung. Sprachsteuerung mit Alexa:)

    Seit Anfang 2024 ist HomeAssistant mit am Start. Was Shelly Cloud nicht kann, bzw. Lokal gesteuert werden soll, übernimmt da übergeordnete System.

  • Yes,

    please have a look here:

    (German thread)

    66er
    14. April 2020 um 11:56
  • It seems that when sensor has access to home network and user can access embedded web interface via access point, then firmware update works without any need for "proxy" etc.

    Therefore I succeeded by following the procedure:

    1.Start with factory reset = unplug batteries, plug batteries back and press and hold smaller hole for 10 seconds (se User and Safety Guide and Press and hold the button for 10 seconds for Factory Settings Reset. Successful factory reset turns on the LED indicator to flash slowly.)

    2. Then with computer, connect to (opened) Wi-Fi network shellydw2-<last-6-characters-from-mac-address> and open the default web page http://192.168.33.1/

    3. In Internet & Security check that CLOUD` is enabled.

    4. Then in WIFI MODE - ACCESS POINT configure some dummy password for another Wi-Fi network shellydw2-<all-12-characters-from-mac-address> and press CREATE Access Point

    5. Connect computer to this Wi-Fi network `shellydw2-<all-12-characters-from-mac-address>` and again open the default web page http://192.168.33.1/

    6. In WIFI MODE - CLIENT connect the sensor to your home Wi-Fi network and press SAVE

    7. Finally go to Settings, choose FIRMWARE UPDATE, press CHECK FOR NEW FIRMWARE and upgrade device.

    Note: now you can delete on computer remembered Wi-Fi networks `shellydw2-<last-6-characters-from-mac-address>` and `shellydw2-<all-12-characters-from-mac-address>`

  • Dieses Thema enthält 3 weitere Beiträge, die nur für registrierte Benutzer sichtbar sind, bitte registrieren Sie sich oder melden Sie sich an um diese lesen zu können.