Shelly and Livolo

Twilight#Wave#4177

Code

Hi, if someone can help me because I'm desperate, I have a Livolo touch switch and I can't make it work well, I have connected it as follows:
The Livolo switch is powered by L and the output to the bulb (L1 load), from here I have put a cable to the SW input of shelly, at the output O of shelly I have put the cable that goes to the bulb ( the same as L1 load), input I and L + fed by phase.
The touch switch works for me, if I turn the light on with the touch switch, I can turn it off with the shelly app, the problem is that if I turn on the light with Shelly, the touch switch turns off the LED and does not work. Someone could help me?
Thanks in advance

Guzzi-Charlie

I'm sorry, but such touch switches which took the N-potential over the load (bulb) are not compatible with Shelly (not out of the box). If you have an electronic switch you'll need a version which has its own power supply terminals "L" AND "N"and maybe a relay as output. This is the same problem you'll have with many motion detectors.

Twilight#Wave#4177

Thanks for the clarification, I could upload a photo with the scheme with a relay next to shelly for the Livolo to work.

Sparkling#Hat#4314

Hi,

i have the same problem... any solution?

Regards,

66er

Hi @koronel22 , welcome to the forum.

Please do not put every text in the code tag.

Thx.