Hello, My name is Juan, I am new in the forum and I use Openhab and Sonoff switches with Tasmota, untill I discover Shelly. They seems to bee fantastics.
I move to a new home and I wanted to integrate shelly in the wall switches. I made some test with MQTT and work fantastic, only I have an issue that I do not know if this is the normal behaviour or not.
- I turn on - off from the Openhab, lights on/off as normal, and I can see the status in the screen.
- I turn on - off from the ext switch, works fine and I can see the status on the screen
- I switch ON from the wall, and then switch OFF from the APP. If I go again to the wall switch, does not turn ON again. I have to switch 2 times.
This behaviour happen independently if the light is ON or OFF. And if I switch first from the Openhab and then from the wall, happened the same. ON from Openhab, then I go to the wall switch, and when I switch, nothing happen, I have to switch again to turn OFF.
I hoped that when you switch ON/OFF from the wall and then from the app, is consistent and react as a Switch independently of there is tension or not.
I followed the wiring from the manual, like this:
Is this the normal behaviour, or I am missing some configuration?
With sonoff, I could connect external switch to the GPIO-PIN programing, and worked fine (it was like an Open C. Close C.)
Thank you for your feedbacks!
[Blockierte Grafik: https://smarthome-forum.eu/index.php?attachment/416-ausschaltung-png/]
