Garage door opens again after closing

dimitrim

Hi,

I connected a Shelly 1 to a Key Automation system that controls my two garage doors (swing gate principle). Seems to be working but when I close the garage doors, it automatically opens the doors again. I don't use a reed switch for the time being.

L&N are connected to 220V. I&O are connected to the Key Automation printboard ports that are also hooked up to a Niko push button.

https://www.niko.eu/en/products/sw…92-a62c7c239cb4

A push on the Niko button typically opens, stops or closes the doors. This also seems to work like that with the Shelly app but when the doors are closed it automatically opens them again.

Any experience with this type of setup and what settings I should use?

Thanks

66er

Hi and welcome to the forum.

AUTO OFF = 2 seconds is set in shelly setup?

dimitrim

Thanks Stefan. Works like a charm now.

66er

Great.

MarySunn

This morning I found that the garage door opened after my wife left and found that it was because the door was currently closing completely and then opening again. I went through the standard steps of checking for obstructions and adjusted the downward force but found that it was already close to the maximum value and moved it to that small amount, but that did not fix the problem. I also tried reducing the cable tension by adjusting the nuts. As a result of unsuccessful attempts at repair, I had to contact the artisans of doorsdirect2u.co.uk, who replaced my gate.