Lights not dimming enough

rjuch

Hi

Has anyone else found that the shelly dimmer 2 doesn't dim their lights low enough? I'm pretty sure my old dimmers, before home automation could dim the lights a lot lower.

I have GU10 LED globes and my dimmer 2 are connected to N. I have noticed this on most lights around the house, some better than others.

Is there anything that can be done to get the lights to dim lower?

Regards

Rich

66er

Hi,

you have done calibration?

rjuch

yeah i have, trailing edge.

Polished#Recipe#19259

I've seen this when calibrated against a different set of lights initially. My issue was anything between 50-100% was 100%, so control was unusable. My steps to resolve were:

1. Calibrate

2. Reboot

3. Calibrate

The "reboot" step seems to help the device do a proper re-calibration against a different load.

notelvisfan

Same problem and I have calibrated repeatedly (trailing edge), trying different firmware versions. I have had my defective dimmers replaced and now I can calibrate successfully (great!). Using 4x Philips 536730 dimmable warm glow LED bulbs.

I have to set the minimum brightness around ~30%, that can't be right, can it?

Lights not dimming enough

Ähnliche Themen

Dimmer is flashing

Power Supply noise

Ligts not dimming and button doesn't work

Dimmer 2 LED compatibility

Dimmer doesn't switch off light completely