Hello everybody,
I recently purchased several 2.5 Shelly for my rollershutters. 3 of them are working fine so far. But for 2 of them, I cannot complete installation. After wiring (like the other ones), I see WiFi AP of the device, start installation of it, but ones my phone (android) get connected to the local AP shelly wifi, I get an error:
"Could not send WiFi settings to device shellyswitch25-XXX. The response from the device was: failed to connect to/192.168.33.1 (port 80) from / 100.121.61.131 (port 50576) after 1500ms.
I already tried several time with factory reset. AP mode comes, but still the same issue. I also tried several places (including a place which works for another one). So it may not be WiFi signal.
I'm a little bit lost, and with nothing else to test. Is there any alternative procedure to install device on my network?
Thank you for your help.