Hello,
I have an issue with 1 of my Shelly 3EM's. It is set up to monitor 3x 1 phase according the "1 phase wiring up to 3 different circuits" as stated in the manual.
When there is no load (0W) on the phase I still see a current of 0.15A and 0.37A. I measured it with a separate clamp meter (Testo 770-3) and that displays the correct 0A.
When there is a load both the Shelly and my Testo display the same value.
Is this a bug? Others have witnessed the same behavior?
Firmware 20201124-092854/v1.9.0@57ac4ad8 but also the same on 20210122-155800/v1.10.0-rc1@00eeaa9b.
PXL_20210306_130600059.jpgPXL_20210306_130622042.jpgPXL_20210306_130748402.jpgPXL_20210306_130908410.jpgFireShot Capture 218 - ShellyEM3 - 10.0.2.171.pngFireShot Capture 217 - ShellyEM3 - 10.0.2.171.pngshelly3emcurrent.png?