Good Morning!
I've seen the thread regarding HTTP Commands and have no issues with understanding it. I'm trying to find out if is possible to include conditionals in the command.
I would like send both the ON and OFF commands in a single URL but only execute the one that is opposite of the current state of the relay.
Does that make sense? I've tried a few things but so far have come up empty.
The use case is that I am using a Shelly i3 with a toggle switch connected to control a Shelly 2.5 with actions but want it to act like it was connected to the 2.5 in edge mode.
Thank you,
Barry
