Beiträge von Randomname123

Zitat

How did you plan to get the status of the door? You would need either a signal from the door controller, connected to pin SW of the Shelly, or a contact indicating the closure of the door. The latter is shown with a nice icon in the app if you attach a Shelly Add-On “plus” on the rear of the Shelly plus 1.

This is the appropriate section of the forum’s lexicon:

smarthome-forum.eu/article/41/

I am very green in electricity so I was hoping for some magic

Shelly Plus Add-On

If I order above, do I need anything else or I have what I need? Which of the diagrams here Shelly PLUS AddOn is for the garage or is there another diagram?

Zitat

In post #1 it looks as if an add-on is already connected, but you can't see anything specific in the photos. Of course, it can also be the case that it is registered but is not actually there.

pasted-from-clipboard.png

Correct its not actually there I was hoping for a software only miracle

So this is the issue I feared...

When you say wiring of the add-on, does it mean there is another hardware addon to be added to the Shelly?

Where do I buy this add-on and is there a guide how to do the wiring?

Thank you

Thank you thgoebel - any suggestions on how to proceed next?

Hi horkatz thanks for your reply! I honestly don't know as it was done by an electrician.

Attached the pictures of the installation.

There are 2x Shelly 1 Plus; 1x for the small gate and 1x for the big gate.

Screenshots above are for the big gate.

Let me know if you need any more information? I can ask the electrician to come back and make changes if required.

Thank you!

Hi all,

I searched for all the threads here on the same subject.

My assumption is that I need to attach something else to the shelly to let it know when the garage is closed or not? Please confirm if the case.

However I am hoping this can be fixed from the software side.

Below the settings how its setup now.

The gate itself opens and works perfectly. Unfortunately its showing as 'open' below while its closed.

Inverting will not help as the timer will automatically put the state back to where it was.

If this cannot be fixed with software would be great if you can send me a link what I need to change in the hardware.

Thank you

Screenshot_20240106_213048_Shelly Smart Control.jpgScreenshot_20240106_213113_Shelly Smart Control.jpg