Beiträge von LUIS2MM
-
-
I thought it was easier, many thanks... it's a 8W/230v ventilator S&P silent-100,
i need a RCFilter... Snubber...
(600V 100nF/100Ω)?.and meanwhile can a keep... the atual instalation (2th picture i posted ").. is it dangerous?
many thanks,
Bom Fim de Semana
-
...the vent should be controlled with shelly and manual switch
-
I've been looking to the tread you mention before and try to translate it
i don't understand why my actual wiring is working... and is it harmful?
and i don't understand why you don't use the Output to give Live to power the vent.
...are you sure that your diagram wont give current to the toggle led indicator.
...if the resistor stops the LED to signal when it's OFF, how it can it signal when shelly turns on the vent. the manual switch is off and line as a resistor as no current in the LED
something like this makes any sense?:
-
Hello All,
My bathroom as a ventilation toggle switch with LED indicator to know that the vent is on.
like this:
i´ve Shelly 1PM Plus to control it. with no success fowling the instruction...
by "accident" this seems to work:
i'm WORRIED this will damage the Shelly device...is this wiring OK?
i've SW-LED-Neutral... ( i've read somewhere that SW as to be connected to L )
it is working...but the led indicator only pops/light if the toggle switch is turn on,
better that this... only... if i can find the way to see the led on/off signal with the ventax on/off set by the 1PM+
CAN I DO THIS"?"?
Thanks in advance.
-
hello thanks for the fast reply...
First the thing i like to implement in my alarm system is to use it to control shelly devices... like open a gate with the alarm remote
the alarm remote can activate PGM's of the alarm and i don´t have wiring infrastructure to get to the door gate so i need it something like shelly.
PGM is an actuator "progamable output" connector it can be switchable to send ground or ~12v ~100mA (+) power...
the board (MG5075) as auxiliator power line that can give 3A ( in total )
so i wish to install a Shelly devise to read the this board output action of a PGM output
-
wow... i need an easy way to undestand how to make PGM in MEGALLAN board... visible to shelly cloud
i did't understand the use of shelly UNI...
where to connect Shelly UNI to?
i assume it can be done with Shelly Plus i4 DC, to read actuation of 4 PGM's from the alarm board, and make an action on other Shelly device.
but i need need help/ guidance to make it happen.
thanks
