Beiträge von Qua334

    Hi,

    I have an electronic door lock with some outputs. 2 of them are ground and reed switch (N.O.).

    Is the correct wiring goes like this:

    > lock's GND wire connected to the DC (-) connected to UNI input 2

    > lock's reed switch wire connected to UNI input 8?

    if not, what is the right way?

    besides, the lock's manual has a comment that the reed switch wire cannot support load greater than 24V and 100 mA. Is this ok with the UNI?

    Thanks!

    Thanks AleXXX and sorry for late reply, I haven't received a notification about your post...

    I haven't checked that part till now, but now I see that I had the "Custom Max Power Protection" set to 1840. Checking on other rollers, I see the same value.

    SO I did the following, while the roller was 100% open:

    1. I changed to 2300 and saved

    2. Sent calibration command

    3. Heard the shelly 'click' but the roller didn't move and calibration failed - tried that twice

    4. I then sent a down command from the web portal an the roller moved immediately. I stopped it at ~90%

    5. Send calibration again but point 3 above happened again.

    So it seems like something else...

    Hi,

    I've seen the other posts on failures in calibration on this forum (hopefully all...) but it seems my case is different.

    I have 11 Shelly 2.5 configured as rollers (and many other 2.5 and 1 as relays). All but one work perfectly! I also have the same roller motor type on all rollers (and they all ~2 years old).

    On one specific roller, Shelly worked for a while and then 'lost it' (literally ;) )

    1. on the internal web site, there is a message "Тo open/close partially go to the settings and do a calibration" instead of the scroll-bar

    2. Doing a calibration process doesn't solve it

    3. Following options 1 & 2 on this post did not work

    4. I also have the following situations when operating manually from the wall's momentary switches -

    a) when clicking once up, it stops ~10 cm before fully open

    b) clicking up again goes to fully open

    c) clicking down from fully open just sounds the engine for a second but nothing moves. It takes another couple of intents to make it start moving down.

    d) it then stops the down move at ~90%. another click down makes it close to 100%.

    On all movements I can see the Watts change on the web site.

    I've also done a factory reset and the FW is latest.

    I'll appreciate any help understanding how to fix it or if the module is defected.