Beiträge von aegDen

I think not. You have 3x230V in/3x230V+120V out 3L/3L+N, and you can use N out only for Shelly supply.

Note: you can make this with 3, 230/230 transformers...

Absolutely right!, sorry.

Then you can made the same but with star/star...

ok, one possibility is putting Shelly1 in ceiling rose and make this conexions in this junctions:

brown from switch1: remove from the actual terminal strip, and connect to Shelly1-L

New wires:

- from Shelly1-0 to brown wires terminal strip

- N to Shelly1-N

- L to Shelly1-L, and Shelly1-I

Remember setting shelly1 button type to "Edge Switch"

Note: I recommend that you use reusable terminal blocks

Good luck!.

I suppose you have 3x220V. Then, I think you can connect N, Va, Vb, and Vc, using a small (25 - 50VA max) 1:1 transformer Delta to Star. In the secondary you will have the same 3 phases that you have in primary plus N.

pasted-from-clipboard.png

Good luck.

OK, I made it!

pasted-from-clipboard.png

Can I use the "separate switch" mode to make a scene on the device itself?

My "when" scene don't work.

• device: Shelly PM1
• Button type: "detached switch"
• Scene:
  When "Shelly PM1-Input" is turned on / Execute scene "One time" with condition valid during "1" minute. Do "Shelly PM1" relay ON after 5', and do "Shelly PM1" relay OFF after 15'.

When I turn On switch, I see in APP that the stick of the button symbol go blue, I waiting for 1, 2,... minuts but nothing happen.

Concretely I use this to control delayed and timer shelly relay in manual mode, because I also control it with " Weekly schedule".

Thanks for your help.

I control a little pump with a Selly1PM. In normal work it make around 700W, off no water the power down to 200W.

I want to protect pump (stop it) when it work off no water. Wonderfull iff it send a message!.

I dont found the way with scenes, neyther with DDD!!! (The only tools I know)

Some master know how?

Thanks.

Thanks #MIHO, although not being able to access that history is a shame.

Perhaps it would be a good configuration option to enable a private place in the user's cloud to store these records.

Hi all,

I don't find information about "event log" file. I see in Shelly app only some ones, but don't know how much registers are availables, and if it's posible to download this file.

Someone can help mi?

Thanks in advance.

I think a possible solution is wiring shelly2.5 as a key switch. But first you need to know if controller board has accesible negative and positive 30V dc. You also need a voltage test (from negative) on the yellow/green wire from the key switch. With that I can try to make a wiring diagram.

Good luck

Absolutely correct!

With this device, the power consumption bypasses Shelly.

For a possible solution (?): I don't know if it is possible to parallel Shelly's four outputs (R / G / B / W), use it as a blank, and use all four channels together in a group (?).

I think it's a problem if you manage any of the four channels independently, and I don't know what can happen.