Beiträge von mackelen

After some tries I managed to do a hard-reset on the device and now the state is also correctly reflected in my Smartthings app when I manually change the state of the Shelly device with the switch. So it seemed it was in a weird state.

Today I tried to configure the same actions on one of my other dimmer2's and they are working with the same url ... I copied the url from the one which did not work and pasted them into the other and that one works. What am I missing here ?

Note: In both cases the Enabled checkbox is marked

I am trying to use the actions when the output is switched on or off to ensure that the state within Smartthings is correct when manually switching the state of the dimmer. However I am unable to get it to work.

It seems I need to use a GET, however I tried accessing both an endpoint on my local network and when this did not work I even made it available externally. However I can not get it to work. Any ideas ?

I also have this temperature issue with one of my Shelly 2 dimmers. The first week it worked flawlessly and suddenly (after a firmware update v1.8.4) it started with this issue. Temperature rises to 105 degrees Celsius in matter of minutes on a load of 72 watts. Dimming down helps to increase the overheating time. 25% keeps it stable at round 80 degrees Celsius.

Downgrading the Shelly to v1.8.2 did not provide an improvement, so it seems it is not related to the firmware. The other dimmers I have upgraded have no issue up till now.

UPDATE: I changed the dimmer from leading edge to trailing edge and did a recalibration and suddenly the temperature started to act correctly again ! As a test I set it back to leading edge and the temperature problem occurred again.