Hi,
I found what was wrong. The single pole swich was connected after the lights wiring instead in front of. Now, everything works fine.
Hi,
I found what was wrong. The single pole swich was connected after the lights wiring instead in front of. Now, everything works fine.
Anyway, thanks for hhelping.
Still no luck, tried everything...
Calibration stuck at 0%, also on one led in ceiling (instead of 8 paralel).
I think the neutral is the problem. I re-used the ground cable as neutral because i can't open ceiling. But i think some other lines are connected to this ground cable. With a normal switch, it works.
I also made a test setup with the dimmer and it works.
I think i have to wait until the sl version comes out.
Is there a possibility to set the max brightness?
Ok, i check it and i try to calibrateagain tonight with the shelly dimmer.
What do you mean with " Did you also join Phillips GU 10"?
How long does a callibration take? If the led lights don't react, do i have to wait,
Yes, several times.
One time it does a callibration, so you see the light dimmed low and going higher. Another time, calibration is failing so i have to reset the device.
Hi all,
Last week, i installed the shelly Dimmer at home. There was no neutral wire, so i put one.
The shelly dimmer works, but i can only dim from 0% to 40%, if i go higher, the light turn off, after some time, the shelly dimmer is offline.
Any idea what this could be?
Dimmer is connected to 8 Led GU10 lights from Phillips (4.2 watt dimmable).