Here: https://smarthome-forum.eu/filebase/index…4-shelly-flood/
it states that the FW of December 14 2019 is the most recent so you might allready have the most recent FW installed.
Did you try to configure the Shelly to use a fixed IP- adress or to get it assigned of your router?
Unfortunately that is already the version that is installed on the flood.
I tried using a fixed IP by DHCP. Do you think it is worth having the fixed IP configured directly from the Shelly?
I saw that thread before and compared the suggested settings, but I've them already. The firmware I see when connecting via AP-mode on the Shelly Flood shows something 2019. Is there something newer available?
Unfortunately I've had no success with the above settings.
Thank you for your quick response. Yes, I can connect via 192.168.33.1 once I keep the button pressed for more than ten seconds.
I call the config page on the shelly flood by opening the above ip on the shelly flood I'm also able to make changes to the device settings, but as soon as I change wifi it never gets connected to my wifi network.
Hello,
I'm trying to use Shelly Flood sensors on my Unifi Access Points, but unfortunately they never get connected. Is there anything I need to consider when using them on Unifi WiFi?
I've already created a separate SSID reduced to 2.4GHz, but even that didn't help.
