Beiträge von Glennbot

How do you configure a i3 as a Shelly Alarm zone?

I also want to use a i3 as an alarm system interface but there is a restriction with the i3. This issue is that the its voltage range is 24-60VDC but the paradox systems runs on 12V. A solution to powering the i3 is to use a step up module like this from eBay:

MT3608 DC-DC Step-Up Converter Booster Power Supply Boost Board

12V in / 24V out.

But I'm not sure how the i3 will interface with the PIR zones.

Let me know if anyone has more info on the i3 trigger inputs.

Glenn

Awesome!!

Thanks

Is there anyway to get the i3 to trigger via a Active AC input opposed to Neutral?

I'd like to connect this in parallel to an existing 240V light switch but the circuit switches Active normally so it's not going to work.

Thanks.

thgoebe - Are you saying Shelly 2.5 only supports AC Current measurement [FACT]?

I have the same problem.

I'm using a 2.4A 24V DC motor and I can almost stall the motor but the current still says 0W

What should I do?