Beiträge von badgerbeard21

    Hey gfyet,

    Also from the UK and trying to achieve the same thing as you!

    I went to TLC and picked up a slightly different sensor from the same range as I ideally wanted a creep zone sensor: https://www.tlc-direct.co.uk/Products/BELC140B.html

    This one I've wired up with the switched output into the shelly switch input, but the switch stays on constantly even if the sensor is off.

    Did you also wire up a capload with the Luxomat sensor you mention?

    If not I'll return them and hopefully the one you mention should work.

    Recently installed an RGBW2 - initially it came up in AP mode fine, I connected, configured wifi and it re-connected in client mode fine. I was able to get to the web interface and change colours, white level etc.

    Some time into using the device I tried to use one of the "Chase Mode" buttons. The lights didn't chase and instead the device webpage suddenly became unresponsive. I removed power and connected again, however the device would not respond or connect to WiFi.

    I followed the instructions for resetting the device using the small button on it, but this did not work. As soon as I press the reset button the LED tape goes green and stays solid, the instructions say it should flash.

    I have tried to reset multiple times following the instructions and it will not go into AP mode.

    I have some experience flashing Sonoff devices and have a USB adaptor to do it, so if support can provide instructions and firmware I might be able to do it, but I also would like to know why it's broken.