Thanks for the reply!!
Sorry, but I don't follow. How do you actually tell it to only output 24V AC?
Thanks for the reply!!
Sorry, but I don't follow. How do you actually tell it to only output 24V AC?
Hello!
I am looking to control the magnetic valves of an irrigation system using a Shelly. The valves needs 24VAC.
As the Shelly Pro 3 has 3 outputs, this one would fit perfect!
The technical specification says 240V AC input and for output it says MAX 240V AC. This would mean I can decide that the output should be 24VAC? I cannot see any jumper or similar, does this mean it is controlled over the software?
Thanks!
Hello,
I've had the Shelly 2.5 installed for over a year and now all of a sudden it started to behave differently. When you click close in the shelly GUI (original firmware) or you click close on the physical switch, the blind is closing fully, then followed by opening up about 10% (blind is open by 10cm from the bottom up).
In the shelly firmware it shows as it being fully closed when it isn't. There is no safety function enabled which would reverse the blind if an object is detected.
I've tried to update the firmware to the latest, I've tried to reboot the device. I've done the calibration twice but so far nothing helps.
Any idea how to debug this problem? Thanks!