I have it installed as follows
Beiträge von ruvigo
-
-
At the moment I have left it as standard without touching any parameter.
It only happens with the vacuum cleaner, but it's not always, sometimes it jumps and sometimes it doesn't, but it's always when with that device.
It happens to me both with the snubber and without it.
-
Good Morning. I recently installed an RC SNUBBER on a shelly 4 pm pro that goes to multi-use and wet-use circuits.
I have the following problem: when I connect the vacuum cleaner, it does not matter the plug and also the Circuit to which it was connected (wet uses and various uses) I get the following message on the Shelly 4 pm pro.
OVERCURRENT
I understand that RC SNUBBER is a filter for voltage spikes as you indicate and in the shelly 4pm instructions it proposes that if you are going to use a vacuum cleaner or induction motor you must use one. I have it installed as indicated. Between the neutral and the output of the shelly
How could I solve that problem? Thanks.
I attach photos of the installation in which said message is seen.