I have a “dumb” EV 3 phase charger.
How can the Shelly 3EM be set up to see the energy going through the charger?
And can I use a Shelly 1 to turn the charger on/off through the pilot cable?
Beiträge von Tirrazo
-
-
Hi,
How do you get the temperature sensor and the addon to work with Shelly?
-
Hey Tirrazo
Welcome to the Forum!
did you take a look into our beginner's Tips? B2 and B6 may could help you
smarthome-forum.eu/thread/508/Hi,
Thank you - that helped me and I have now been able to add it to my account!
I still can't get the temperature addon to work. We bought the addon and 1 temperature sensor to work with Shelly to measure temperature.
After watching a video, this looked pretty simple. Just connect the cables and plug the addon with 5 pins into the serial port of Shelly while it's powered off.
After powering it back o, the temperature is not visible in the app.
Regards
-
Hi,
I am a brand new user and I just bought my first Shelly 1. After reading the instructions, I followed the steps closely to add the device to my home network and the app, but it's not sccessful.
Now it is located under "hidden devices" as Offline / Pending connection.
This device is brand new from the store and has never been connected to a network before.
This happened the first time also so I have reset the device (5 times on/off sw) once before.
Now I need some help because I just can't get any further.
It's a 2.4 GHz network, I find the device and connect to it through the app. Then the AP network shows up on my wifi and I connect to that also. That is basically where I am at now.
Regards