Hello, I'm sorry but I'm confused, if a resistor is to be added in parallel, shouldn't appear in the manual or wiring diagram?
[Blockierte Grafik: https://smarthome-forum.eu/media/451-ar768-leistungsmessung-png/]
Hello, I'm sorry but I'm confused, if a resistor is to be added in parallel, shouldn't appear in the manual or wiring diagram?
[Blockierte Grafik: https://smarthome-forum.eu/media/451-ar768-leistungsmessung-png/]
Hello, have you received any reply from Shelly or found a solution?
I got a similar issue. It worked for a while but now I only get the voltage reading.
It seems out of sync but I can't figure out why.
The clamp is on my main supply and the heat pump and it show 0 W even though I should get readings.
Also tried to reboot, power on/off, delete/add the device but without any change.
It's a motion 2 and it worked!
Firmware 2.1.8 seem to be available as well but everytime I try to update, it goes back to v2.1.7
Hi
I want to use the Alarm mode to trigger the horn.
So if i activate the alarm mode if there's any intrusion the horn will make noise.
I know i can set a scen with the Sensor but it's much more easier only tap on activate alarm to have that alarm active, i really don't know why that isn't possible....
Were you able to find a way to do it?
Hello!
I had the same idea, I tried but couldn't get it to work. It seems the button cannot deactivate the motion sensors either.
I believe it would be possible to use 2 Shelly 1 in series. One activated by the button, the other one by the scene. The shelly 2.5 might be able to do it in a single device.
But I'm not an expert
Hello,
I like the idea too!
At first, were you able to toggle it based on your PV excess production? If so, how did you manage? With the Shelly app or home assistant or something else?
Thanks for your feedback