Beiträge von Mikael Kermorgant

So I now have a bit of data to share, and the results aren't really great (the voltage difference being quite low so accuracy wouldn't so good I guess).

voltage at around 18.1° : ~ 6.2v

voltage at around 5.5° : ~ 7.4v

temperature comes from a ds18b20 sensor really close to the thermistor

1702542066_grim.png

Any idea if I could improve a bit on this ?

Thanks !

Actually I read the add on characteristics again and found this mention :

Supported sensors

• Up to 5 DS18B20
• Single DHT22
• NTC resistors with 10 kΩ nominal resistance and β=4000 K

I'm not sure if my thermistor qualifies with this requirement but it doesn't look too far off 🤔

Hi,

I have a shelly 1 pm plus and an addon, and a thermistor NTC (24 kohms at +5 degrees, 10 kohms at +20 degrees)

The doc has this ratings https://kb.shelly.cloud/knowledge-base/shelly-plus-add-on

So it seems my thermistor is out of range, right ?

I was hoping to more or less follow the setup described here : https://kb.shelly.cloud/knowledge-base…-photoresistor-

Now I'm trying to understand a bit deeper how things work : is R1 here an internal resistance of the addon ? If so, do we know its value ?

I tried to wire the thermistor between GND, ANALOG IN and VREF + R1 OUT and got some voltage readings around 6v in Shelly UI, but not very stable, changing constantly between ~ 5.80 and 6.20v (at a 17 degrees place).

Any news on this ?

My latest experiments have shown that using a custom topic prefix including slashes like house/basement/boiler-room was problematic. Mqtt explorer would stop receiving the status updates.

But with the default topic prefix, it works

Hi, did you find a solution for this ?

Hi,

I am also having issues with such kind of mqtt things since I updated firmware to 1.0.3 version

Even the "Generic status update over MQTT" aren't visible (using mqtt explorer to see what's coming to the broker)

Hi,

Somehow related but I started integrating a shelly pm with mqtt and got some initial stuff working, but nothing works since updating to latest firmware

Hi,

I was hoping to make a PATCH http call to interact with my mikrotik router's config but it turns out I get this response "method': Method is wrong or not supported!"

   Shelly.call(
    "HTTP.REQUEST",
    {
      method: "PATCH",
      url: baseUrl + "/" + id,
      ssl_ca: "*",
      body: body,
      headers: headers
    },
    function (res, error_code, error_message) {
      print(res);
    },
    null
  );

Is there any hope to get that supported in a coming firmware update ?

Thanks